Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / j. a
Actually the ACB is abbreviation of Air circuit breaker,
which is normally used for LV switchgears and high current
(normally more than 400A). The switching contacts are
operating in the air. MCCB is abbreviation of moulded case
circuit breker which is normally used for switching of load
less than 630 A.
| Is This Answer Correct ? | 22 Yes | 0 No |
Post New Answer View All Answers
why we change the direction of winding in rotor ?how we make the north and south pole?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
What will be result if we connect LT votage to the terminal of HT motor?
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
send me all basic electrical question and answers
design a 3 bit synchronous and asynchronous counter using T- flipflop
Instrument connected to a single phase supply
is there any phase difference occurs while primary and secondary side mutual induction occurs?
Merits & Demarits of Oil circuit & Air circuit breakers ?
Transformer how to maintaince a check b check c check d check
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
Why reactive power is needed in a power system? How is it being absorbed or delivered by alternators? For reactive power control we are changing excitation but reactive power absorbing or delivering related to stator. How these two are interlinked? i want a detailed explanation with necessary expressions and figures?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
how to calculate IR value of 33KV cable ??
Why IR value of the (HT cable Plus synchronous motor) is less while individually having IR values in GΩ?
