Interested to Buy Any Domain ? << Click Here >> for more details...
If R and Y terminals are short circuited,then power will
cut. we all know that power cannot be stored.what will
happen to already generated power at power station?
- 3 Answers
- 6200 Views
- I also Faced
- E-Mail Answers
Answer Posted / hm
when L-L fault occurs, electrical power Pe (generated by
alternator) becomes zero but mechanical power Pm (turbine
giving to alternator) remains as it is i.e. Pm > Pe. so
alternator tries to retain its stability(see power swing
curve for details) by deaccelerating rotor(up to synchronous
speed).if area under acceleration is equal to area under
deacceleration machine retains its stability else protecting
relay trips the machine.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
do we use links in a dc circuit?if so what s its use in it?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
What is the drawback of class b amplifier?
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
If UG power cable both ends are to be earthed or what? If not why?
how to calculate transformer load?
Grid fault level [KA]?
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
How to test lightning Arrester?
do you have some of interview Questions in power and genrator section in general whith answers
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
pre arcing time of ehv breaker
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
operation of protection relay watchdog contact?
should %impedance be high or low in a power transformer? if so why?
