Interested to Buy Any Domain ? << Click Here >> for more details...
I saw one P&ID 6" control valve has been connected with 8"
process line, and 2" valve also connected in parallel with
6" valve. why the 2" valve connected in parallel, Is there
any technical reason. please clarify. With Regards-Kittu
- 5 Answers
- 10796 Views
- GNFC, I also Faced
- E-Mail Answers
Answer Posted / chowdary
The controller name is Split Range controller.
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
How to calibrate Field bus transmitter? procedure ?
Turbidity analyzer working principle ?
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
what is the responsibility of an instrument commissioning supervisor
can you send remote seal interface level transmitter calculation steps for oil water saperator.
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
please send the sample qustion paper for iocl written test ..
PLEASE PROVIDE SAMPLES OF CHEVRON SKILL TESTS
what is performance test.need defination
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
How RAL(Rotary air lock)works in cement industry?
What is Positive Calibration and Negative Calibration?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
