in our sub station why we step down firstly 33kv\11kv then
11kv to 430v. can we direct step down 33v to 430.v.
Answer Posted / vrs rathore
Yes we can, but if our exixting system is workable for only
11kv and required capacity is more then 4000kva then we
have to take 33kv connection and after that it has to step
down 11kv for supplying our esisting system, which is
working only for 11kv/430v.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
i am completed diploma in ece,and working in ht and lt lines.so is elligible diploma in ece for get electrical C Licence?plse give ur opinion?
How do we calculate transformer oil in liter from the rating of the transformer.
what will happen if i connect 12 volt battery with 24 volt battery charger.
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
What is DTR erection?
What is ramp signal?
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
what is the prinsiple of dc motor and construction and working ,application of dc motor.
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
bus bar design conditions and sizing pls tell me quickly
what is thresold of perception
What is an iron loss or core loss pi?