Answer Posted / mohamed
NPSH Available should be more than The Rquired NPSH.
I mean that the pressure at the suction eye of the impeller
should be more than the saturated pressure for the pumped
liquid otherwise the pumped liquid will start to evaporate
and cavitation problems will start.
i will mension here some reasons for cavitation:
- pump selection is not correct
-suction tank is not in a proper elevation.
- isolation valves are partially closed
- mesh size of pump strainer is not correct
- pump strainer is partially blocked
- the system is not vented in aproper way .
- tempertaure of pumoed liquid is deviated form normal
values.
still many reasons are there , but finally you should keep
the pressure at pump suction more than saturated pressur.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
Why pistons are usually dished at top ?
We select 10mm nominal thickness for Elip head of a pressure vesel. The minimum thickness after forming is 8.2mm. (Shell thickness is 8mm. The minimum thickness after forming is satisfied or not with UG-79 (d)(3) in ASME SECTION VIII, Div.1?
When effect of variations in specific heats is considered then how do maximum temperature and pressure vary compared to air standard cycle ?
What is, if any, the orientation of the horizonal seam on ERW welded pipe
What do you understand by critical points in iron, iron-carbide diagram ?
Please advise your reasons for applying for this role and why you think you are suitable?
WHAT IS DENSITY OF AIR AND PETROL MIXTURE IN 2 STROKE S.I.ENGINE
what is the required force to bend 2.5 MS sheet in 90 degrees and what is the formula to calculate the same?
Explain the formation of micro structures of pearlite, bainite and martensite in steel?
What is a machine shop?
What is the purpose of air blow?
how the efficency of a coupling is calculated?
How to Start Boiler Electrical Feed Pump? I mean to How to Charge it?
How to disiegn DCV circuit ?
When maximum discharge is obtained in nozzle ?
