Interested to Buy Any Domain ? << Click Here >> for more details...
The command "show IP protocol" displays which information?
A. routing timers
B. network information
C. contents of the IP routing table
D. information about all known network and subnetworks
- 4 Answers
- 21559 Views
- Facebook, I also Faced
- E-Mail Answers
Answer Posted / george
To display the parameters and current state of the active
routing protocol process, use the show ip protocols command
in EXEC mode.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What do you understand by redundancy?
Name the command we use for ping in ipv6?
What is the beaconing?
Define mac address?
When we use interface mode?
What is the virtual path?
What does aaa stands for?
Which command we give for see routing table?
What are the possible ways of data exchange in ccna?
Explain the difference between tftp and ftp application layer protocols?
Which LAN switching method is used in CISCO Catalyst 5000?
what command you must use if you want to delete or remove the configuration data that is stored in the NVRAM?
What is the difference between hub, switch, and router?
Is hsrp is cisco proprietary or introduced by ieee?
What route entry will be assigned to dead or invalid route in case of RIP?
