Answer Posted / sridhar nayak
by the help of tester the insulation of the cable canbe
measured. the simple technique is just raotate the handle
of the megger and place the test prod one on conductor and
other on the insulation it should not show less then 2mohms.
Is This Answer Correct ? | 16 Yes | 2 No |
Post New Answer View All Answers
How to calculate energy stored in an inductance?
what is the meaning of vcc
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
distribution transformer de-rating formula on over limit iron losses
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
Could you measure voltage in series?
How to test IR testing & magnetic balance test
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?
Why Stabilising Resistor used in REF circuit ?
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
How to find ampere on ht side for selection of cable size ???