whyvibration probe (bently nevada ) is set -10 volt for
zero reference?
- 2 Answers
- 6963 Views
- I also Faced
- E-Mail Answers
Answer Posted / p.n.shaji
Hello
See some comments
http://www.control.com/thread/1026233734
Regards
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
send me last 5 years questions asked in rrb chennai, for section engineer
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
use of split range ? where it is used ? in which control loop it is used ?
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
this site is owned by an nonsense
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
principle of dead weight tester ?
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
can any send me a forbes marshall dtron 316 manual
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
