Interested to Buy Any Domain ? << Click Here >> for more details...
What is the acceptable earth resistance for Commissioning
the Transformer?
- 6 Answers
- 11028 Views
- HSL, I also Faced
- E-Mail Answers
Answer Posted / madhusudhana
It should be less than 0.5 ohm.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What do you mean by cogeneration? What its working principle?
What is precision of a measurement?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
What is non-minimum phase transfer function?
what are types of encoder
How to run a three phase motor into single phase........
HOW TO CALCULATE ELECTRICAL, MECHANICAL,& OVERALL EFICIENCY OF GAS ENGINE POWER PLANT
what is booster? and how it is connected in a circuit?
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
what type of questions are asked and howmwny questions belong this catagory?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
I am going to appear for the RRB Chennai Section Engineer online exam. Please send me the question papers from 2001 to date to my mail id:upendrakrishna20@gmail.com,plz send me ,or send any other rrb papers plzzzzzzzzzzzzzzzzzz
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
