why is the vector group analysis done in transformer tests
- 28 Answers
- 66718 Views
- K K Rao, Lloyds, Nicco Engineering Services Limited, Qatar Petroleums, I also Faced
- E-Mail Answers
Answer Posted / j
To determine phase displacement
| Is This Answer Correct ? | 231 Yes | 13 No |
Post New Answer View All Answers
Define the three phase formula fuse.
How does the phase sequence controller works, how it identifies the phases? confirm working principle
What is EMC filter in VVVF Drive ?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
What are the causes for the failures of sandwich type (Al) busducts?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
When we need up only in o/p 440v, so why we use directly in 11kva in input?
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
Define pole pitch?
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
How can we increase fuel-power ratio of any DG set?
Define the term factor of inertia.
Explain cos(theta) and Sin(theta)
