Interested to Buy Any Domain ? << Click Here >> for more details...
What is use of 3phase instead of single phase?
- 12 Answers
- 16527 Views
- DCM, L&T, I also Faced
- E-Mail Answers
Answer Posted / sunil guru
IN 3-PH COMPARED TO SINGLE PHASE LOSSES ARE LESS..
LARGE POWER IS TRANSMITTED SO THAT A GREATER NEED CAN BE
FULFILLED..
WE CAN TRANSMIT POWER TO A LARGE DISTANCE WITH LESS COST OF
TRANSMISSION AS COMPARED TO SINGLE PHASE.
IN INDUSTRIAL SECTORS THE MACHINERIES AND EQUIPMENTS ARE OF 3-
ph SO 1-PH CANT BE MADE INTO USE...
FOR ANY DISAGREEMENT MAIL ME AT parmar20072008@yahoo.com
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
What is a dc motor?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
How to test Alternator stability test for REF relay
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
Define active filter?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
What is inrush current? how can calculateit? what is the affect of it?
why constant voltage transformer should be start without load? and if started then what will happen?
What is the basis for framing the rules of block diagram reduction technique?
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
What is slip in an induction motor?
Difference between Lugs and Thimbles
