Interested to Buy Any Domain ? << Click Here >> for more details...
I have three phase 400 KW,390 A MOTOR.For this motor which type
of Cable is required....specifically rubber cable required. Can
anyone help me..
- 5 Answers
- 9184 Views
- I also Faced
- E-Mail Answers
Answer Posted / padmakumar
Cable size selection is dippending on several factors like
current,distance,cable routing, nature of load,duration of
running of equipment etc.Normally 400KW LT motors nobody
prefers to run due to high current handling.HT motor is
preferable.In case of LT, you can go ahead with 400sqmm two
runs of Alumonium cable with stardelta starter.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Draw a SLD of HT distribution EB grid up to users Transformer?
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
what is the Transformer Impedence?How can calculate?
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
What do you mean by a current transformer?
what is the importance of earthing system on the generators big capacity and small?
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
What will happen if the d.c. Machine is operated below rated speed?
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
in 6.6 kv vaccum circuit breaker vaccum bottole vaccum capacity ????
how to set relay setting? and example calculation...
