Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / s,hosad
OPC stands for “ OLE for Process control” , again OLE
stands for “Object Linking and Embedding” , to link the
different objects from different user and make it used or
available in DCS for process a task, OPC server is used.
| Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
How to Calibrate Flammable gas detector in field
How to calculate mmwc values into tonnes?
for oil & gas industries which zone is normally preferred? why? give its example?
Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?
What is force balance principle? State some of its’ advantages.
how to tune siemens sipart electro pneumatic positioner..plz tel me..
Please can anybody help for control valve sizing step by step procedure?
why we are not using the turbine flow meter in the steam service?
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
what effects a surging can produce in the compressor
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
which processor is used in dcs.
Explain operation of Haskel pump.
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
