what is start up vent valve ? why it is used in boiler?
Answer Posted / raja.k
The vent valve kept open while start up boiler is called
start up vent valve.
This valve is usefull to vent low temperature & pressure
moisturised steam. as well sa to raise steam pressure
slowly.
Is This Answer Correct ? | 104 Yes | 15 No |
Post New Answer View All Answers
What is 3 element control system
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
what is exact time to study dcs and plc cources
Why boiler chimney area oxyden sensor fixing?
Why do you want to work here
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
What is Erosion in a control valve?