Interested to Buy Any Domain ? << Click Here >> for more details...
How voltage regulation is calculated for over head
transmission line? What do we mean by Conductor constant
while calculating voltage regulation? how it is differ for
for diffrent type of conductor say AAAC DOG & AAAC RACOON
conductor?
- 3 Answers
- 21228 Views
- ABB, AES, I also Faced
- E-Mail Answers
Answer Posted / vinaya
Calculation of voltage regulation is an important part of power system analysis.
ACSR, AAAC conductors of different sizes are available. Usage of a particular conductor depends on factors like voltage rating of the transmission line, power factor, total load, length of the line etc. For example following are the KW-KM values for 1% voltage drop at 60 deg C at P.F
1.00 - 41613; 0.9 - 25438; 0.8- 20966; 0.7- 17787 FOR acsr Coyote 26/2.54 + 7/1.91 conductor.
Generally the formula used for calculation of Regulation is
% regulation @ --- p.f = KW-KM X RC of conductor/P.F x D.F
| Is This Answer Correct ? | 14 Yes | 6 No |
Post New Answer View All Answers
what will be the min and max voltage flow from neutral to earth?
What are the advantages and disadvantages of open loop control system?
draw 3 phase rectifier diagram
Whar is the KvA rating of 33Kv substation & actual kv rating of power generaating station.
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
in science exhibition how lamp can blink when you clap near the lamp ? thank you
what is meant by impulse voltage?
what are the advantages and disadvantages of speed control of 3 phase induction motor by varying frequency explain with drawing
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
What is the formula to calculate the rating of a three phase air circuit breaker
Why DG set is not installed in Terrace ??
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
Classify driling machines.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
do we use links in a dc circuit?if so what s its use in it?
