Interested to Buy Any Domain ? << Click Here >> for more details...
in our sub station why we step down firstly 33kv\11kv then
11kv to 430v. can we direct step down 33v to 430.v.
- 18 Answers
- 43441 Views
- Eaton, Siemens, I also Faced
- E-Mail Answers
Answer Posted / anuj
Yes we can step-down the voltage directly from 33kV to 430V
but it is not feasible since transformers turns will
increase which will ultimatly increases the cost and
secondly laod centres are far more distance than the S/S
which will increase the LT line and eventually the losses
are more in LT line than the HT line.Therefore from S/S to
the load centres, HT lines are running and near the load
centre distribution transformer is installed.By this way we
can reduce the LT line and ultimatly the losses
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
. What is Electrical Life & Mechanical Life of Circuit Breaker? 2. What is Electrial Life & Mechanical Life of Magnetic Contactor? 3. What is RCD, RCCB & RCBO? 4. What is the Between defferance of RCD, RCCB & RCBO?
You are of electrical field and you are going for software? Why
How to calculate ant test the burden of Current transformer
STATE USE OF ARC RUNNERS & SPLITTERS ?
is it possible to test of bus bar in high rise building without completed full floor ?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
how many safety really of DG sets.
why the check zone and main zone are used for Busbar Protn. scheem?
Single line diagram for dbb (double bus bar)system.
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
why a tester wont shock while testing the power in house
what do you mean by class PS CT and what are technical details needed for calculating it?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
