Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gnb
First I have explain about Loop Check. Loop check means
that we have to check the functionality of Field
Instruments to DCS/PLC.
For Valves,you have to simulate the value from DCS/PLC in
step by step(0%,25%,50%,75% and 100%).Valve actuation to be
confirmed by actuator Scale which is in the Valve.
| Is This Answer Correct ? | 21 Yes | 0 No |
Post New Answer View All Answers
we are using centum vp as monitoring with Dell precision work station T3600 but some times PC(s) are restarted automatically . how we can solve this problem? thanks
What is super thermocoupal?
how to turbine speed measurement?
what is the process for double acting cylinder pneumatic for 32' v/v
How to find out the current of two motors having same power consumption but different RPM?
how is work pressure switch& level switch?what is the principle of this?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
flow transmitter formula?
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
Full form of KKS when use DCS.
plz tell me clearly about PID.."when v have to change I value,D value,GAIN??
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
