what happens when one of the phases out 0f 3 phases
been removed under working condition and no load condition
will the machine run if so plz send me why
- 2 Answers
- 3608 Views
- I also Faced
- E-Mail Answers
Answer Posted / gunasekaran
this condition is single phasing it is continuouly rotate
but not full speed and it draw more current from other 2
phase nearlly around 2 time of normal curren
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is phenomenon of electromagnetic induction and how it works?
what is physical distance of isolator to VCB in 33/11kv sub stations
defination of lines
why normally Generator rating are between 11Kv to 22Kv?
What is shunt voltage and u v voltage witch one best
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
Basic motor transformer generator
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
actually i can't understand what is 3dB ? and it's really not clear to me.please any one let it me be cleared.
what is the difference b/w absolute encoder and incremental encoder?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is Control & Relay Panel? And Remote Control Center?
Differenciate between circuit wiring and sub main wiring with illustrations
