Answer / gunasekaran

this condition is single phasing it is continuouly rotate
but not full speed and it draw more current from other 2
phase nearlly around 2 time of normal curren

Answer / george

if load condition means m/c will stop.
if no load means not in full speed in depends up on HP

why weight is put on pulley?

1 Answers  

---

what is servo motor and how it works?

0 Answers   Godrej,

---

What is the difference between earth and neutral

4 Answers   ABB, Tamboli Engineers,

---

What are the voltage values for LT,HT,EHT and other voltages??

22 Answers   INEL, MNC,

---

we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???

0 Answers   NTPC,

---

After synchronization with grid how to maintain the power factor in lagging or in leading? if lead of lag what is the problem?

3 Answers  

---

is there a different b\w ground fault CB and earth leakage

1 Answers  

---

Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0

0 Answers  

---

What is transient Phenomenon?

0 Answers  

---

What happens when reactive power enters a system?

6 Answers  

---

what is phase to phase voltage? what is line to line voltage

46 Answers   Exmar, HBL Power Systems,

---

There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?

0 Answers  

---