If the supply voltage is same (say 440V) whether a system
designed for 60 Hz frequency will work with 50 Hz frequency
or not , if so pl. give clarification.
Answer Posted / nitin palaskar
yes we can do it by giving supply to rectifire and convert
into d.c. then give it to inverter we get 50hz supply
frequency
Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
Salient pole alternator is more stable, why?
how to calculate the size of the HT cable
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
which type of questions asking for solar companies?
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
how can calculate resistance box for 15 kw, 6 pole, RV-230, RA-42 motor
How can we design a HVAC Plant room which includes AHU,FCU,Chillers,Cooling towers, Pumps etc & how will they work? any Drawing if possible?
How to know of any cable size if there are not written on cabl?
what is the string efficiency
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
What is dynamo?How it works and what is the function of dynamo in a DG.
Why we are use dol starter up to 10 hp