Answer Posted / nitin palaskar
because at 0.8 p.f. we can get min or zero regulation.
which can not get on the unity p.f.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to compute kvar in substation feeder to improve power factor and sending voltage
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
Define peak time.
I am an American living in Vietnam and I have recently gotten a refrigerator from Japan and it is rated for 100 vac, but the power here is 220 so I bought a voltage stabilizer it has a 1 kva output rating. Can you please tell me what the amperage is? I'm confused and without a working fridge.
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
which type of questions asking for solar companies?
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how to calculate the distance relay faulty zone?pls explain?
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
Use of switch mode power converter in real-time basis?
What is boucholz relay and the significance of it in to the trformer?
You are of electrical field and you are going for software? Why
