how to connect from a line-to-line connection to a line-to-
neutral connection?
- 6 Answers
- 7305 Views
- I also Faced
- E-Mail Answers
Answer Posted / jq
To have a line to neutral connection, all you have to do is
to take out one of the leg connected in line to line and
then connect it to the nuetral line.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the Minimum winding resistance of motors ( small & big)? referance range
What are the function of different components of servo motor?
What happen to generator if i have unbalanced load?
Sate maximum power transfer theorem?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
how much GROUND & NEUTRAL VOLT maintain in data center.
What is Meter MF if External CT Ratio is 150/1 , PT Ratio is 132/110 Meter CT Ratio is 200/1 & Meter PT Ratio is 110/1
TRANSFORMERS WITH DC SUPPLY
What is block diagram?
Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?
What is Scheme Test of High Voltage Switchgear. Which tests it includes.
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
What is the effect of positive feedback on the stability of the systems?
how to calculate units consumption for a 12 hp motor /hr.
