wat s reactive power.... how could it be compensated.....
Answer Posted / ramanjaneyulu
Power has two components - active power that is used in
doing useful work and reactive power that is a loss to the
system. Reactive power is given by sqrt(3)*VISin(phi)in
case of three phase power supply.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the voltage regulation for unity and zero power factor?
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
how generator avr give to the input?
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
How to find ampere on ht side for selection of cable size ???
we use capister for power factor. when we use capaciter in dg circuit than defect dg. can we use capaciter bank for dg circuit
What is Negative Potential Bias
what is class of SPD and dittels of all class ?
how can i get an electrical c-certificate?
HOW DO YOU CAN CHECK A 15KV DIODE, WHETHER IT IS OK OR NOT?
What are the application of filter?
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
What should be the height of basement according to NBCC code?
Define load factor?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.