Interested to Buy Any Domain ? << Click Here >> for more details...
HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN
ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii)
DELTA LOAD, USING A CLAMP METER.
NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO
WE GET?? PHASE CURRENT OR LINE CURRENT.
- 13 Answers
- 36285 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / sumit dhar
Lets say we are using transformer,
A delta star transformer, the 3 phases coming out of the
star side of the transformer are the red, yellow and blue
wires abbreviated as R Y and B. The Current flowing through
these wires is the Line current. Using a Clamp meter, we
should clamp the meter to one of the wires say R phase. The
measured value will b Line current passing through R phase.
If the load is Balanced load, then equal amount of current
will flow through the Phases R Y and B respectively. After
that we can measure the Phase current using the formula
given above.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
what is the grounding Calculation formula? spouse i want to provide grounding to 3phase 18kw motor or i want to provide ground to 3phase 10kva dry type transformere or you give me any exemple...... Thanks.
what is meant by impedance & transient protection?
Transformer cores are laminated in order to A simplify its construction B minimize eddy current loss C reduce cost D reduce hysterisis loss
How many size of cable required for a 300m long and 30kw inductive lode
How to design the NGR Resistance
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
why core is useful for a transformer ?and also in its operation ?
what is the need of starter in tube light and what type of starter is used in that?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
What is conventional thermal current (Ith)
11000volt DG set carnt kaise banvay
l&t switch FN 63 handle position can we change
I Just want do EHS Certified Certification Distance Course From Govt approved,so can any body provide me details.
explain the process of commutation in a dc machine. Explain what are inter-poles and why they are required in a dc machine.
Why wind turbines wheels rotate constantly
