Interested to Buy Any Domain ? << Click Here >> for more details...
FOR WHICH FAULTS OR CONDITIONS DOES A TRANSFORMER
DIFFERENTIAL PROTECTION DOES NOT OPERATE???
- 10 Answers
- 14099 Views
- I also Faced
- E-Mail Answers
Answer Posted / thiru
transformer differential protection does not operate when
there is out zone fault.because that time two sides of CT's
sense same current. there is no difference of current.so
the relay does not operate.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
Please explain me about Relay curves and their sources to read ?
How to check the cable fault / hv test of transformer cable.
what are the preventive maintanance actions taken for air circuit breaker? please answer me
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
How time response of the system is divided?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
Q) Write VBscript code along with QTPscript code in QTP tool for below scenario 1. Launch yahoo site(i know) 2. Do loogin(i know) 3.Click inbox link(i know) 4.Go to every page of mail box and count no.of read mails and no.of unread mails(i know) 5.Store page numbers, read mail count and unread mail count in a new excel file sheet 6.Create 10 types of graphs on that data 7.Do logout and close site(i know) 8.Save new excel files with graph
block diagram of 2 ups system connected in parallel mode?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
