Interested to Buy Any Domain ? << Click Here >> for more details...
what is the uses of C.V.T transformer in switch yard?
- 4 Answers
- 11417 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / shashank22_sahu@yahoo.co.in
yes
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Why compensation is necessary in feedback control system?
State angle criterion.
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
Currently what is the highest capacity (MVA) of SPPg generator available in the market?
How many types of oil using in H/T & L/T Oil Circuit Breakers. need Explenation ?
How to calculate loses in transformer of 160 KVA ?
How out of step protection relay works?
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
What are the two major types of control system?
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
whate is the meaning of balance/unbalance,in stabilizers type
what are the applications of PLC?
What are the various types of rotor used in the alternators?
how to calculate magnetic force genrated by a coil ?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
