Interested to Buy Any Domain ? << Click Here >> for more details...
Why do we use only Sinusoidal Wave in AC supply why not the
Square,Triangle or Sawtooth etc?
- 2 Answers
- 6915 Views
- I also Faced
- E-Mail Answers
Answer Posted / r k sinha
there r mainly two reason for using sine wave in ac supply:
(i)it is easy to produce by rotating coil under magnetic feild..and
(ii)all the function exist in world can be break down under the summation of many sine function by a method called fourier transformation..so it is easy for us to derive all result for sine wave...
| Is This Answer Correct ? | 17 Yes | 0 No |
Post New Answer View All Answers
When lag/lead/lag-lead compensation is employed?
According to underground cables a) stress b/w sheath & conductor is high b) inrush of core & conductor
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
Why is back emf used for a DC motor? Highlight its significance.
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
Describe the control mechanism of missile launcher???
What would be the size of wire used for 2 Ton of window A.C?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
hai...... tis is Hemanth. jst now completed electrical engineering... i wanna to apper for ap tranco exam... plzz send me the previous q's paper link......thanx in advance.
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
What do you mean by pull of electromagnet?
What are the different circuits in thermal power plant?
How to calculate the value of earth capacitance in a transmission line.
How two nos. 130 kw D.C motor get synchronise using D.C drive.
