Interested to Buy Any Domain ? << Click Here >> for more details...
We have laid the single core Armoured cable 7 nos ( 2 each
phase & 1 neutral ) to cater our electrical load .
the issue is though we have Glanded the cable both the end
also givan the earthing to the panel both the end we are
facing a heavy sparking at the gland side. what could be
the reason.
- 12 Answers
- 17056 Views
- I also Faced
- E-Mail Answers
Answer Posted / k sharma
It could be any nearby electrical machine not being
properly earthed and it is taking earth from this gland
leading to heavy sparking.For eg there could be a welding
machine nearby and the work may not be properly earthed.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
What is CVT and what is relation with wave trap?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
what is the use of piston rings in the engine used for a generator...........
what is the difference b/w pvc cu conductor and cu breaded wire..?
1. transformer design formula ? 2. how to calculate the primary turns and secondry turns ? 3. core types ? 4. how to find the primary current and secondry current ? 5. how to calculate the stacking factor ? 6. range of fulx density ?
how to calculate the battery AH
electrical knowelge
what is meant by LCR meter? where its useful ?
what is residuel magnetism. and how order lead acid batteries for 24 volt. emergency lighting system.
What is meant by stator? What is meant by rotor?
How can we increase fuel-power ratio of any DG set?
How to calculate main incomer rating of APFC Panel ? Let's say i want to find main incomer for 11kV, 1000kVAR Panel.
What is meant by harmonic distortion?
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
