How to calculate earth flat size for 250 Kva DG and
transformer?
Answer Posted / rsbangra
what is the voltage level ?
kva =1.732*v*i
i=kva/1.732*v
we get current value then find out current carring bus size
Is This Answer Correct ? | 8 Yes | 8 No |
Post New Answer View All Answers
How Calculet The UPS AH In Load
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
What is the difference between a Root Locus plot and a Bode plot?
Why star delta starter is preferred with induction motor?
What is the normal phase difference between the voltage and the no-load current in a transformer?
what are factors to be consider to design a HT & LT motor?
block diagram of 2 ups system connected in parallel mode?
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
What is the difference between electrical earthing and electrical grounding?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
how to discharge 3 phase power factor correction capacitors