Interested to Buy Any Domain ? << Click Here >> for more details...
i have one tank of 500mm height, which is in under vacuum of
735 mmHg, I want measure level of the same using DPT , SO WHAT
WILL BE THE URV & LRV, DENSITY OF THE TANK FLUID IS 0.95. is
there necessary to fill the LP side with fluid.
- 7 Answers
- 16789 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitin
thanks Sam!
u really increased my knowledge.
& also i get the result
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Draw a great bridge circuit.
what are procedure of sox-nox calibration
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Instrumentation Safe Guarding test. How to determine the interval time of the test. eg:Halfyearly,Every year,Every three years etc.
Explain the difference between plc and cnc?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
wich is coming the first HAZOP OR SIL
why Fahrenheit unit of moistur analyzer transmitter
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
Give Detail information about plc,dcs,and scada system?
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
what is droop in governer ,type of droop ,how it work
Why humidity limit is 30 to 55 % for raw material storage?
