Interested to Buy Any Domain ? << Click Here >> for more details...
What is use of 3phase instead of single phase?
- 12 Answers
- 16962 Views
- DCM, L&T, I also Faced
- E-Mail Answers
Answer Posted / balaji
1.if we use all loads in a single phase voltage drop will be
high.instead of that if we use 3 phase then load will be
shared by each phases ,so voltage drop will be less.
2.we can use 3phase load as well as 1 phase load in 3phase
4wire system.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
Differentiate between digital phase converter and ordinary phase converter.
What is the difference between the impedance percent and impedance voltage ?
Why using synchronising methed in DG's sets?
write a c++ code that receives an integer number and display the sum of the number and its revers integer?
How we can calculate the life of Lead acid battery
What is Fire Panel ? How it works ?
what are the main faults that occur in stabilizers? How they corrected and resolved ? Types of stabilizers ?
what parameters are should nessary for control technic dc drive(in rolling mills)?
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
How to synchronization will be done between two DGs ?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
List the advantages of star-delta starter with induction motor?
Why derivative controller is not used in control systems?
Any one can explaination about calibration with rotating sub standards?
