Interested to Buy Any Domain ? << Click Here >> for more details...
what is the uses of C.V.T transformer in switch yard?
- 4 Answers
- 11295 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / balaji
1.we cant measure directly very high voltages(in kv) in
switchyard.so we need to step down the voltage in kv into
some small values.so we can measure small voltages using our
meters.the purpose of using capacitor is to filter DC and
will allow AC only.
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
What is proportional controller?
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
What is limitedly stable system?
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
how to increase or decrease speed in DC shunt motor by DC convertor
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
why are the maintaine power factor and how can this control and this is how work.
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
what is the meaning of impedance protected in instrument cooling fan
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
The loads are connected with phase and ground then why current flow as the loads ?
