Interested to Buy Any Domain ? << Click Here >> for more details...
what is actual difference between pressure Transducer &
Pressure Transmitter.
- 5 Answers
- 12372 Views
- I also Faced
- E-Mail Answers
Answer Posted / sam
Transducer is any device that can converts one type of
energy into another type of energy. In a pressure measuring
instrument the transducer is the actual pressure cell that
converts the measured pressure energy into a proportional
electrical energy.
This pressure cell is connected via a ribbon cable to the
head of the pressure measuring instrument where the
transmitter is situated.
Transmitter is any device that can take a generated signal
and transmit that signal via any means, be it via cable or
radio waves to a receiver.
We normally refer to any measuring instrument's transmitter
section due to it being the most important area to us. The
transmitter's ability to transmit the generated 4 to 20mA
signal is what we work on and not the cell or transducer area.
If you talk about your car do you talk about your 4 cylinder
or do you talk about your Toyota Corolla?
Good luck
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
why we take %i0.0 as input for twido plc
what about your moleg in pogrees with company
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
diff between neutral ,ground,phase , earthing and shielding?
TEMPERATURE VARIATION FOR FREQUENTLY.
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
how can use ram
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
How to convert milliampares into flow??
Name different types of bourdon tubes.
What is frequency factor in massflow meter? When using frequency output?
what should he know if he is an assitent engineer instrumentation in cement industries of experience of 10 - 15 year.
