can we connect both delta and star to the transformer
secondary and for what reason?
- 5 Answers
- 7679 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / power srikanth
yes....for transmission we connect secondary in delta and
for distribution we connect in star fashion becoz in star
neutral wire is available
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
how to calulate short circuit current for the following: 1.cable connecting 11KV of 22KV/11KV transformer to 11Kv of 11KV/415V transformer 2.what cable size should i use.
How we calculate the size of ht cable for any transformer
is that any software calculator to calculate the size of cable
What is the formula for calculating no-load current?
State ohm’s law?
Why does increasing the magnetic flux in the main field of a d.c motor cause the armature current to reduce??
what is the solution for meger test failed the MV cable?
How to define Kirchhoff current law and voltage law along with simply examples.
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
How to design harmonic filter at the project stage without nowing the harmonics levels
Haw to check conductivity of budbar
What is meant by cold loop test in instrument
What are the factor to be consider for CT selection in 132kV substation?
