Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / girish rawat
THE LEAST COUNT OF THE LEVELLING STAFF WAS 5MM EARLIER.
NOWADAYS YOU GET LEVELLING STAFF WHICH HAS 1MM ACCURACY ON
THE REAR SIDE. CHECK IT OUT
| Is This Answer Correct ? | 38 Yes | 7 No |
Post New Answer View All Answers
how many shuttering material required for 1000 sq.m built up area.
please what are the required bars for a beams of 6mx6m and 450x300mm, one is continuous and the the second is discontinuous ..Its a commercial building (church)
What are the govt approvals required for starting of power project. means from initial site grading and excavation work.exm. blasting in hard rock, deep excavation, cut off trees from site.
What is meant by scaffolding coefficient?
Why should pumping be not used in case of concreting works?
4. Differentiate between NC and OC soils. Draw curves for (i) Stress vs Strain (ii) Volume charge vs Strain (iii) Pore pressure vs Strain for these soils
What is the difference between Grade I, II and III of GSB?
How much does the leaning tower of pisa lean?
why is the column design?
How did the romans get water up hills using aqua ducts?
What is thumb rule for deep trench excavation
How to calculate the cement plastering for circular and rectangular water storage tanks and how to calculate the area of circular and rectangular floor?? Please help me
In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.
In Abutment walls (A1 side) why we are adopting fixed bearing (POT-PTFE)?
if in column reinforcement lower dia connect to higher dia then from wher we want to start higher dia steel
