10. THE MOST COMMON TYPE OF THREE PHASE IN UNSYMMETRICAL
FAULTS IS ........
Answer Posted / ashish
line to ground fault
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
How to know the Max. current caring capacity of the cable by its size ?
how you will decide the distance between the power transformer and its fencing
Draw the circuit of clapp oscillator?
draw the full wave and half wave circuit of 3 phase system and inverter circuit used in upsĀ
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
why chock were used in old tubelights but are not newest tubelights?
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
how solar power plant energy meter multiplication factor
What is EHT tariff or Power factor Tariff ????
Differentiate between low pass, high pass and band pass filter?
i have a 1500kVA transformer what is the kWH meter i need to use?
sir my exam is on 19/6/2013 under electrical branch pls send me sample aptitude questions as well as sample technical questions for jindal steel and power company
Give details on how you intend to handle a challenging position you are posted to manage unexpectedly as a company staff?