Which three statements about Frame Relay configurations
using subinterfaces is true? (Choose three)
A. Each subinterface is conferred either multipoint or point
to point
B. Any network address must be removed from the physical
interface
C. The configuration of subinterfaces is done in router
(config-if)# mode
D. Frame Relay encapsulation must be conferred on each
subinterface
Answer Posted / simals
A B C
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Do you know how many types of data?
What is the subnetmask of / 27 in network based and host based?
Given the configuration example: interface ethernet0 ipx network 4a ipx access-group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network tc access-list 800 permit 3d 4a Which action result from implementing this configuration? a-Traffic from network 3d for network 4a will be forwarded out e0 b-IPX network 5c will not receive any traffic c-Traffic from network 3d, destined for network 4a, will be forwarded out e2 d-Traffic from network 3d for network 3d will be forwarded out e0
How do you find valid hosts in a subnet?
Is hub intelligent device?
Which protocol you manually enable route summarization?
Explain the difference between simple authentication and md5?
What is the difference between ‘bit rate’ and ‘baud rate’?
Suppose there are 3 pc's pc1 pc2 and pc3 all are connected with each other pc 1 is able to ping pc2 and pc3 but pc2 and pc 3 not able to ping pc 1 then what is an issue troubleshoot it?
How does cut-through LAN switching work?
What is the difference between csma/ca?
What is the ieee standard for wireless networking?
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?
What are the differnt memory use in cisco router?
hi friend i am sending some interview question which is asked from me at volvo hope this will help you of all 1 what is mpls al question is posted by jitendera kumar sinha