Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Difference between E/P Positioner and I/P
positioner in a control valve? In which applications the
respective positioners are used in?
- 18 Answers
- 77534 Views
- ADCO, I also Faced
- E-Mail Answers
Answer Posted / s.m.patel
I to p means input signal is 4-20MA
E to p means input signal is 0 to 10 VDC
| Is This Answer Correct ? | 7 Yes | 19 No |
Post New Answer View All Answers
whats the abbreviation of IOP? is it instrument of power or input open problem?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Why do we have earthing cable in branch cable and shield in the same cable?
What is frequency factor in massflow meter? When using frequency output?
draw shematic diagram of c/v positioner(smart type)?
where uses EXe /EXd/Exo/Exn/Exp/Exq/EXia
what is exact time to study dcs and plc cources
What is eddy current? Describe the operating principle of proximity probe.
what is basic difference between motion balance and force balance in pneumatic instrument?
what is actual drum level and compensated drum level?
what is the difference between -24 : +24 & 0:24 and where it use?
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
Question on maha cement
how to calibrate load cell
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
