How to protect the water pump by no load running.
- 9 Answers
- 11648 Views
- Cushman Wakefield, I also Faced
- E-Mail Answers
Answer Posted / parth belani
We can protect a pump from no load running by using a
minimum recirculation line. This line connects outlet with
the main tank or the inlet. so there will always be some
minimum flow through the pump.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What does the term power factor shows?
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
What is the formula for calculating the Instantaneous Short Circuit & overcurrent for any breaker
briefly explain the main blocks found in a microprocessor based system
what is different between phase and netural
How to calculate VA rating for CT or PT or Control Transformer?
what is plunger and what's the use of it in motor alignment?
I want to make street light with solar system ... What may I do for procedure and how much of estimation for each material ... If any one knows guide me and inform this id : aravindd7@gmail.com
HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?
What was the Dg set radiator and lube oil temperatures trip in ACB
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
what is the basic need of domestic loads 1- voltage 2- current
how the inner and outer body is separated in aircrafts?
how we provide neutral earth on synchronising panel as per electrical standards?
How to measure the earth resistance value in a concrete pavement(flood light area)?
