Why the Transformer connection is changing in different
transformer?(Like Star & Delta,Delta & Delta,Star &
Star,Delta Star)
From that connection where it is used?
Answer Posted / j.b.
(1) in the star - star connection 57.7% of the line voltage
is impressed upon each winding, but full line current flows
in each winding. power cicruits supplied from a star -star
bank often create serious distrubance in communication
circuits in their vicinity. It is seldom used.
(2) The Delta Delta connction is often used for moderate
voltages. An advantage of this connection is that if one
transformer gets damaged or if removed from service,the
remaining two can be operated in open delta or V-V
connection, but the capacity of the bank is reduced to
57.7% of what it was with all threee phase are in working.
(3)The Star Delta connction is suitable for step down a
high voltage. In this case, the primary is designed for
57.7% of the high tension lines.
(4) Delta Star connction is commonly used to step the high
voltage.
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the earth treantment procedure?
100 MVA 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase. what will be the fault MVA of generator.
How to calculate impedance volt in Transformer?
Why front mounted CT polarities are always towards breaker?
How to work meggar?
What is the function of the generator exciter?
What are the operation carried out in thermal power station?
What is the meaning of HT Trivector Meter ?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
how we explain parallel paths armature winding?
Which do you think is the most significant cause of energy loss in a factory?
How to maintain ac plant?
what's the difference between 'shaft power demand' and 'BHP' , when we consider electrical load list.
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?