What type of protective system we uses in L.V. distribution
panels?
Answer Posted / nagesh
current protection
1)over current
2)short ckt current
3)Instantanious current
Earth fault relay,
Negative phase sequence
Phase failure
If require
High temprature
High vibration
Safety (door switches)
MD over shoot(MD monitoring)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what happen if drive input fail momentry at 48.5 HZ frequency?
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
What is the difference between isolators and electrical circuit breakers? What is bus-bar?
What are the two types of compensation?
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
what is the difference between megger and earth resister ??
when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//
can we make a electric generator,which can not use any type of fuel,air,solar,gas,thermal,coal,petrol,etc and able to produce electrical energy (or self electricity generating generator)
STATE USE OF ARC RUNNERS & SPLITTERS ?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
Operation of isolators.
draw the block diagram of fire alarm?
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points