Answer Posted / ghanshyam tiwari
yes,I have a PLC in my orgnisation
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how the inner and outer body is separated in aircrafts?
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
how to determine Sq.mm size of finolex power cables.
How does cost of generation from hydropower plant compare with other sources of electricity?
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
how to calculate the step resistance for slipring induction motor,how you deside the no of step for that?
draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.
How is the percentage impedence of a transformer fixed at design stage???
what is gas turbine intercooling ?
WHAT IS THE MEANING OG (li = 7 In)
why three phase capacitor takes unbalanced current in capacitor bank?
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
