Answer Posted / touch2gobi
Derating Factor value depends upon the motor environment,
For example:
Motor design temp – 45 deg C
But motor location ambient temp 65 deg C (near any burner
or heat source)
So motor performance (rated power) will reduced due to
ambient temp.
For that motor manufacturer given Derating Factor value.
Ex:
Rated power = 45 kW
Derated power = 42 kW (Operating Temp – 50 deg C)
| Is This Answer Correct ? | 25 Yes | 19 No |
Post New Answer View All Answers
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
what is the procedure of belt scale calibration?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
the whole paper was based on Transducers..questions like define repeatability, error,accuracy,precision..den there were many q. on the conversion of Pa to mmHg and other units.. also..der wer few Q. on some level sensors(with diagram)
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
What is cut off relay? And why use in PLC and DCS?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
Hi Friends i am going to write BARC written test by this month 20th (20-5-2008). So please if any body knows the details about this or having previous question papers pls mail me to kkumarei@gmail.com. For Suggestions give one message to 9962122264
How will you calibrate PID controller? explain with example.
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
Explain the working principle of lvdt?
What is the minimum rating availalbe for weld neck orifice in market?
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
What are the interlocks we have to check during the start up of LP/HP compressor?
