Answer Posted / sivasankari
1.The ability to pay careful attention to details
2.Good communication and reading skills,
3.Manual dexterity and patience
4.The ability to lift between 11 and 25 kilograms
5.Good mathematical, scientific, mechanical and logical
reasoning abilities
6.The ability and desire to keep up-to-date with
technological developments in the field
Is This Answer Correct ? | 17 Yes | 10 No |
Post New Answer View All Answers
pls give me presant awerness quistion and answer in my emailid.
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
What is cut off relay? And why use in PLC and DCS?
what is gas metering system? gas chromatograph? and gas compressors?
What is Cavitation in a control valve?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
Describe how to use megger to measure the earth resistance and insulation resistance
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
steps for installing orifice plate?
any body please send me the old question papers of ongc test.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
How many interlocks at turbine side?
key exchanges in wpa,wpa2,tls
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?