What is the difference between compensation and extension cable.
Answer Posted / touch2gobi
Compensation cable used for thrmocouple application only.
this cable transmit the signal from sensor to tranmitter
without any signal loss, without signal noise.
Extension cable just use for Extension purpose
Any comments, Please welcome (touch2gobi@yahoo.co.in)
Is This Answer Correct ? | 13 Yes | 25 No |
Post New Answer View All Answers
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
where cascade loop use ?
How the warning lamp of a charging-system is activated ?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to Calibrate Ultrasonic Level Transmitter in field
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
NSV type probe stands for
How to erection of DCS Panel at site step by step
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
how many types of preheaters are in cement industry & what r they can any body explain?
key phaser where is use and work
Which type of pressure can be measured by primary elements?
what is KV and XV valve
Difference between ultra sonic flow meter