Interested to Buy Any Domain ? << Click Here >> for more details...
how does electrical train works and what type of motors are
used to drive the train?
which level of supply voltage is used?
- 22 Answers
- 65249 Views
- Alstom, Infotech, I also Faced
- E-Mail Answers
Answer Posted / s.vasanth kumar
Electic train works by giving supply to the motor through
the transmission line it may be A.C supply or D.C supply.a
collector is used to collect the supply from the
transmission line and it is given to the A.C motor or D.C
motor.The motor is driven by using gears and belts.
D.C series motor, A.C series motor & a.c induction motor
are the motors used to drive the electic train.
25kv a.c supply or 600v,700v D.C supply
| Is This Answer Correct ? | 10 Yes | 11 No |
Post New Answer View All Answers
How can we calculate cable size in Low voltage & high voltage
we have one oven for 12 zone we are installed ir lamp in oven we control load from thyrister and 0 to 5vdc so our zone no 8 getting bright in fraction of second so what we do.. Please answer
what kinds of Transformer oil grade is better for power transformer ?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
What is industrial plc
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
TRANSFORMERS WITH DC SUPPLY
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
we are small scale industry in production of rice & rice bran. Pls let me know how to take contract demand for our industry.. (for information we have total 600.hp)
design a 3 bit synchronous and asynchronous counter using T- flipflop
how can i improve the power factor in domestic (230v)
