Interested to Buy Any Domain ? << Click Here >> for more details...
why 4 to 20 ma ,why not 0 to 20 or 3 to 15 or anything
- 19 Answers
- 48162 Views
- Honeywell, TCS, TN, I also Faced
- E-Mail Answers
Answer Posted / pradip
*To determine live zero
*To avoid noise
*Linearity is maximum
*Transmission of signal over long distace
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how to work static pressure sensore how to work dpt
How would you choose differential range?
How to Calibrate Flow Switch in field
Hi, I am Newely Joined in Construction company instrument engineer? Any one can Plz tell me How can I advanced preparation for Releated Engineering and construction Documents?
How to Calibrate Level Troll in field
What is limitation of the ht.of the displacer of a level trol?
what is the diffrence between pressure safety valve & pressure relief valve....pls
why would you like to join our company
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
can u briefly explain aboutan aryton shunt multirange DC ammeter?
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
what is sil (safety integrity level
why is not useing in boiler skin thermocople
