Answer Posted / bhaumik

In the 2-wire transmitter 24VDC power is given. The +ve of
the 24V is connect to +ve of the transmitter, -Ve of the
transmitter is connect to +ve of the Indicator & -ve of the
indictor is connect to -ve of the 24Vdc powersupply.

god evening sir i am studying m.sc(tech)electronics &instrumention.am i elegible to all industies

1858

---

what does it mean an active front end in vfd plz explain it briefly

1938

---

what is diffrance between FF & SMART, explain with difination

3288

---

how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line

2160

---

There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?

2011

---

How does temperature bath work? How does coil gets heated only by applying some current?

1873

---

How does your previous experience relate to the job you are applying for ?

2086

---

Please can anybody help for control valve sizing step by step procedure?

2195

---

What are the interlocks we have to check during the start up of LP/HP compressor?

2041

---

Senior engineer's please help me, what is Loop Checking and Loop test? and write difference also? soon urgent

2175

---

send me last 5 years questions asked in rrb chennai, for section engineer

2146

---

I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?

2117

---

Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.

1934

---

which type of zones used for boiler? & why ?

1912

---

How to calculate mmwc values into tonnes?

1310

---