Interested to Buy Any Domain ? << Click Here >> for more details...
as i m an electronics engineer,and doing testing course,if
interviewer ask me a question that after being an
engineer,why u choose testing field,what should i answer?
- 2 Answers
- 5799 Views
- IBM, Nokia, I also Faced
- E-Mail Answers
Answer Posted / abanirout
Answer to the question depends on your attitude and
interest.But I would like to say about why engineer like to
take this field is as follows.......
Working on electronics ckts on component level is of an unique
experience ,it very interesting to experience the basic
working princeples implimented in the ckt.It clears the basic
fundamental of electronics from root level.........
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
State the difference between ac and dc voltage.
What is the difference between power amplifier and voltage amplifier?
can we calculate the voltage level for microwave energy which is using for our mobile communication?
How many types of Transmission cards are in Ultra BTS?
what is the difference between electrical and electronic choke.. and whats the main advantage of elecronic choke?
How does data transfer takes place between memory and input output ports?
A PLL maintains lock by comparing A The phase of two signals B The frequency of two signals C The amplitude of two signals D None of these
syllbus for the aptransco for ece
what are the basic courses can be done for ece branch?
how do link aT1 from the 1st BTS to 2nd BTS4?
In the OTA, the transconductance is controlled by A The ac supply voltage B A bias current C The input signal voltage D The manufacturing process
Q.1what is E1? Q.2what is diffrence b/w RNC & BSC? Q.3what is STM? Q.4what is LAC & CI? Q.5 what is HSN, MAIO, MA Group & frequency hopping?
What is static resistance of a diode?
One week before i was joined in one rfid based company.i don't know about the future of that field.can you tell me that future.
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
