If one lamp connect between two phases it will glow or not?
Answer Posted / isda
IF THE VOLTAGE BETWEEN THE TWO PHASE IS EQUAL TO LAMP VOLT
IT WILL GLOW
BUT IF IT IS BIGGER IT WILL DAMAGE
IF THE VOLT LESS THE LAMP GLOWING WILL DEPEND ON THE TYPE OF
THE LAMP
Is This Answer Correct ? | 49 Yes | 6 No |
Post New Answer View All Answers
Any one can explaination about calibration with rotating sub standards?
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
What is the formula to calculate the rating of power cable for three phase current.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
How the over load setting for HT Motors calculated-provided in Numerical Relay
Is there possible to Test Transformer for Overfluxing Capability. Or is there any firm who does Overfluxing Test on Transformer?
At what factor resistance r of a conductor depends?
what is the principle of operation of tungstun bulb ??
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
what is tri state logic gate
what is the size of ht cable of 33kv ht line and transformers ratings are 1 Mva and 5mva.please send formula also.
is all the servo motors having brake?please specify which servo motors having brake for stop on position and which are not.
Are Refrigerators & Deep Freezers the Inductive load ? How to calculate the Power Factor & hence the Output Power for them ?
What is the complete procedure of erection of electrical panel in industry